HP 1650B - Timing Waveform Configuration

ACCumulate
ACCumulate
command/query
The Accumulate command allows you to control whether the chart
display gets erased between each individual run or whether subsequent
waveforms are allowed to be displayed over the previous ones.
The Accumulate query returns the current setting. The query always
shows the setting as the character “0” (off) or “1” (on).
Command Syntax:
:MACHine{ 1 12):lWAVeform:ACCumulate
(setting >
where:
c setting > ::= {O~OFF}or{l~ON}
Example:
OUTPUT XXX;“:MACHINE1:TWAVEFORM:ACCUMLJLATE ON”
Query Syntax:
:MACHine{ 1 /2}:TWAVeform:ACCumulate?
Returned Format: [:MACHine{l I2}:TWAVeform:ACCumulate] {Oil) c NL>
Example:
10 DIM P$ [loo]
20 OUTPUT XXX;” :MACHINEl:TWAVEFORM:ACCUMULATE?”
30 ENTER XXX; P$
40 PRINT P$
50 END
lWAVeform Subsystem
19-6
HP 1650B/HP 16518
Programming Reference