1. Remove the four Phillips M2.0 × 2.5 screws (1) that secure the touchpad bracket to the computer,
and then remove the bracket (2).
2. Remove the tape (1) from the connector on the touchpad.
3. Disconnect the cable (2) from the touchpad ZIF connector.
4. Peel the touchpad cable (3) off the touchpad.
5. Remove the three broad head Phillips M2.0 × 2.0 screws (4) that secure the touchpad to the
computer.
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
