6
NOTE:
To disconnect the console cable, plug out the RJ-45 connector of the cable and then the DB-9 female
connector.
Connecting the AC power cord
To connect the AC power cord:
1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2. Make sure the correct power source is used.
3. Connect one end of the AC power cord to the AC-input power receptacle on the switch.
Figure 21
shows the power cord connection on the switch.
4. Connect the other end of the AC power cord to the AC power outlet.
5. Check the Power LED. If it is ON, it means the power connection is correct.
Figure 21 Connecting the AC power cord
To Next Page
Loading...
