HP 1910 Series Getting Started Guide

7
Verifying the installation
After you complete the installation, verify that:
• There is enough space for heat dissipation around the switch, and the rack or workbench is stable.
• The grounding cable is securely connected.
• The correct power source is used.
• The power cords are properly connected.
• All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
strip with lightning protection and lightning arresters for network ports have been properly
connected.

HP 1910 Series Specifications

General

PoE Support	No
Type	Managed
VLAN Support	Yes
MAC Address Table Size	8192 entries
Jumbo Frame Support	Yes
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	10% to 90% (noncondensing)
Uplink Ports	4 x SFP