HP 1910 Series Getting Started Guide

1
Appendix C LED description
Power LED
The power LED shows the operation status of the switch.
Table 6 Power LED description
LED mark Status Description
Power
Steady green The switch is operating properly.
Flashing green The system is performing power-on self test (POST).
Off The switch has been powered off or the power supply failed.
Ethernet copper port LEDs
Table 7 Ethernet copper port LED description
LED mark Status Description
Link/Ac
t
10/100BAS
E-T port
Steady green The port is operating at 10/100 Mbps.
Flashing green The port is sending or receiving data at 10/100 Mbps.
Off No link is present on the port.
10/100/10
00BASE-T
port
Steady green The port is operating at 1000 Mbps.
Flashing green The port is sending or receiving data at 1000 Mbps.
Steady yellow The port is operating at 10/100 Mbps.
Flashing yellow The port is sending or receiving data at 10/100 Mbps.
Off No link is present on the port.
SFP transceiver module link LED
Table 8 SFP transceiver module LED description
LED mark Status Description
SFP transceiver module
link LED
Steady yellow The port is operating at 100 Mbps.
Flashing yellow The port is sending or receiving data at 100 Mbps.
Steady green The port is operating at 1000 Mbps.
Flashing green The port is sending or receiving data at 1000 Mbps.
Off No link is present on the port.

HP 1910 Series Specifications

General

PoE Support	No
Type	Managed
VLAN Support	Yes
MAC Address Table Size	8192 entries
Jumbo Frame Support	Yes
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	10% to 90% (noncondensing)
Uplink Ports	4 x SFP