EasyManuals Logo

HP 2000i Reference Guide

HP 2000i
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
HP StorageWorks 2000 G2 Modular Smart Array Reference Guide 111
6. Quit the FTP session.
7. If the updated disks must be power cycled:
a. Shut down both controllers by using SMU.
b. Power cycle all enclosures as described in your product’s user guide.
NOTE: If you loaded firmware to a Seagate 750-Gbyte Barracuda ES SATA drive, after spin-up it
will be busy for about 50 seconds completing its upgrade. Then it will be ready for host I/O.
8. In SMU, verify that each disk has the correct firmware revision.
9. Resume host I/O.
Installing a license file
1. Ensure that the license file is saved to a network location that the storage system can access.
2. Open a Command Prompt (Windows) or a terminal window (UNIX) and navigate to the directory
containing the firmware file to load.
3. Log in to the controller enclosure that the file was generated for:
ftp controller-network-address
For example:
ftp 10.1.0.9
4. Log in as an FTP user.
5. Enter:
put license-file license
For example:
put certificate.txt license
A message confirms whether installation succeeded or failed. If installation succeeds, licensing
changes take effect immediately.

Table of Contents

Other manuals for HP 2000i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 2000i and is the answer not in the manual?

HP 2000i Specifications

General IconGeneral
BrandHP
Model2000i
CategoryDisk array system
LanguageEnglish

Related product manuals