HP 2520-8

2 – Index
using CLI session … 4-12
debug command
IPv4/IPv6 event messages
… 4-11
IPv6 event types supported
… 4-11
show debug
… 4-14
using Syslog servers
… 4-12
default settings
IPv6
nd ns-interval, 1000 ms
… 1-15
nd reachable-time, 3000 ms
… 1-16
ping6 data-size and data-fill,
0
… 4-4
ping6 repetitions, 1
… 4-4
ping6 timeout, 1 second
… 4-4
traceroute 6 defaults
… 4-6
deprecated address
… 1-18
DHCPv6
does not assign link-local address
… 1-7
mutually exclusive with autconfigured
global unicast address
… 1-5
mutually exclusive with static global
unicast address
… 1-8
precedence over autoconfig
address
… 1-8
server-assigned global unicast
address
… 1-7
supported with DHCPv4 on same
VLAN
… 1-8
displaying debug configuration
… 4-14
DNS
configuration
… 4-8
domain-name
… 4-9
view configuration
… 4-10
documentation
feature matrix
… -6
latest versions
… -5
release notes
… -5
E
EUI
in IPv6 address
autoconfiguration
… 1-5, 1-11
used in IPv6 address
autoconfiguration
… 1-3
event log
compared to debug/Syslog
operation
… 4-10
debugging by severity level
… 4-11
debugging by system module
… 4-11
Event Log Message Reference
Guide
… -5
TFTP upload on remote device
… 2-18
F
FE80
link-local address prefix
… 1-4
flow sampling
… 2-21
G
gateway
determining default IPv6 route
… 1-25
global unicast address
autoconfiguration
… 1-5
autoconfigured is mutually exclusive
with DHCP server-asigned
address
… 1-5
deprecation
… 1-28
manual configuration
… 1-10
preferred lifetime
… 1-5, 1-7, 1-9, 1-28
valid lifetime
… 1-5, 1-7, 1-28
H
HP Networking
switch documentation
… -5
I
ICMP
bucket-size
… 4-2
error-interval
… 4-2
rate-limiting controls
… 4-1