To Next Page

To Previous Page

Setting up the monitor

WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper

workstation setup and proper posture, health, and work habits for computer users. The Safety & Comfort

Guide also provides important electrical and mechanical safety information. The Safety & Comfort Guide is

available on the Web at http://www.hp.com/ergo.

IMPORTANT: To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the

panel may cause nonuniformity of color or disorientation of the liquid crystals. If this occurs, the screen will

not recover to its normal condition.

IMPORTANT: To prevent the screen from getting scratched, defaced, or broken and prevent damage to the

control buttons, position the monitor facedown on a at surface covered with protective sheet foam or a

nonabrasive cloth.

Removing the stand’s hinge blocker

The monitor is shipped with a hinge blocker that locks the monitor head in the lowest height position on the

stand. You must remove the hinge blocker to adjust the height of the monitor head.

To remove the hinge blocker, gently press down the monitor head (1) and pull the hinge blocker out of the

stand (2).

4 Chapter 1 Getting started

Questions and Answers:

Need help?

Do you have a question about the HP 25x and is the answer not in the manual?

HP 25x Specifications

General