To Next Page

To Previous Page

Display Mode

The display mode of the monitor is reported in the monitor status message that appears when the monitor is

turned on and when the video input is changed. The current display mode is shown in the Information menu

window and at the bottom of the OSD’s main menu in the status bar area. Modes of operation are Normal and

Adaptive-Sync.

To turn on the Adaptive-Sync mode:

1. Press the center of the OSD joystick to open the OSD.

2. In the OSD select Gaming.

3. Select Adaptive-Sync, and then select On.

NOTE: The Adaptive-Sync menu default setting is On.

Using Auto-Sleep Mode

The monitor supports an OSD menu option called Auto-Sleep Mode that allows you to enable or disable a

reduced power state for the monitor. When Auto-Sleep Mode is enabled (enabled by default), the monitor

enters a reduced power state when the computer signals low power mode (absence of either horizontal or

vertical sync signal).

Upon entering this reduced power state (sleep mode), the monitor screen is blanked, the backlight is turned

o, and the power light turns amber. The monitor draws less than 0.5 W of power when in this reduced power

state. The monitor wakes from sleep mode when the computer sends an active signal to the monitor (for

example, if you activate the mouse or keyboard).

To disable Auto-Sleep Mode in the OSD:

1. Press the center of the OSD joystick to open the OSD.

2. In the OSD, select Power.

3. Select Auto-Sleep Mode, and then select O.

14 Chapter 2 Using the monitor

Questions and Answers:

Need help?

Do you have a question about the HP 25x and is the answer not in the manual?

HP 25x Specifications

General