This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against interference in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause interference to radio communications.
Installing this equipment in an FCC Level B product results in an FCC Level A Composite System (as defined
in the FCC Rules and Regulations) when attached to an Ethernet (IEEE 802.3/802.3u) or Token Ring (IEEE
802.5) network.
European Community
This is a class A product. In a domestic environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.
Electromagnetic Emissions
FCC part 15 Class A (U.S.A.), ICES-003 (Canada), CISPR-22/EN55022 Class A, AS/NZS 3548
(Australia/New Zealand).
Note: For EU compliance, see the Declaration of Conformity.
Safety
Products comply with:
IEC 950: (1991)+A1,A2,A3,A4/EN60950 (1992)+A1,A2,A3,A4●
UL 1950●
CSA 950●
Australia
This equipment complies with Australian EMC requirements.
Canada
This equipment complies with Canadian EMC Class-A requirements.
Declaration of Conformity
DECLARATION OF CONFORMITY
according to ISO/IEC Guide 22 and EN45014
To Next Page
Loading...
