HP 4262A User Manual

Section IV Model 4262A
Test Program 8
PERFORMANCE TESTS
TEST PROGRAM 8
[PURPOSE]
This program checks function of 4262A ADDRESS switch (rear panel) and verifies
that the address code set into the switch provides access to the 4262A by the system
controller.
Note
To perform this test, set ADDRESS switch
(ref to Para 3-68) according to calculator dis-
play and, after setting the switch, press cal-
culator CONT button.
[PROGRAMMING]
Annotation
is
omitted.
prt "REM ADDRESS TEST";spc 3
dsp "Set up oW *ADODRESSABLE ";beep;stp
rem 7
cli 7;cir 7
dsp "Set up A5-A1=00000";beep;stp
700+A;5s80 "CHR"
dsp "Set up A5-A1=30001";beep;stp
TJUl=»a;9s8b "CHK"
Gsp "set up A5-A1=00010";been;stp
9: 702+A;g9sb "Cik"
10: dsp "Set up A5-Al1=00100";beepr;stp
11: 704+A;9sh "Cag"
12: dsp "Set up A5-A1=01000";beev;stp
13: 708-»A;gsp "CHK"
14: dsp "Set up A5-A1=10000";beep;stp
15: 716+A;gsb "CHK"
16: dsp "Set up A5-41=10001";been;stp
17: 717+A;gsb "CHR"
18: prt "TEST EnD";spc 3
19: end
20: "CHK":dsp "Check *LISTEN=1 *REMOTE=1";beep;wrt A;wait 2000
21: dsp "Check *TALK=1l *REMUTE=1";beep;red A;wait 2000
22: cli 7
23: ret
*11359
+
se
v
se as
[caRE
NN
NI
.
[RESULT]
Both 4262A LISTEN and REMOTE lamps illuminate for two seconds. Successively,
both TALK and REMOTE lamps light for two seconds. Calculator prints TEST END,
4-34

HP 4262A Specifications

General

Brand	HP
Model	4262A
Category	Measuring Instruments
Language	English