4. If it is necessary to replace the hinge cover, pull either side of hinge cover to disengage it from the
display enclosure, and then remove the hinge cover from the display enclosure.
The hinge cover is available as spare part number L83730-001.
When replacing the hinge cover, make sure the hinges rotate downward as far as they can go. Align the
cover, and then start from above and rotate the cover downward onto the hinges. Make sure the clips
snap into place along the bottom of the display cover.
5. If it is necessary to replace the display hinges:
a. Remove the six Phillips M2.5 × 2.5 broad head screws (1) from the bottom of the hinges.
Component replacement procedures 59
To Next Page
Loading...
