Page 18-2
Enter object, type the name of the stored object using port 3 (e.g.,
:3:VAR1), press K.
Recalling an object from the SD card
To recall an object from the SD card onto the screen, use function RCL, as
follows:
• In algebraic mode:
Press „©, type the name of the stored object using port 3 (e.g.,
:3:VAR1), press `.
• In RPN mode:
Type the name of the stored object using port 3 (e.g., :3:VAR1), press
„©.
With the RCL command, it is possible to recall variables by specifying a path
in the command, e.g., in RPN mode: :3: {path} ` RCL. The path,
like in a DOS drive, is a series of directory names that locate the position of
the variable within a directory tree. However, some variables stored within a
backup object cannot be recalled by specifying a path. In this case, the full
backup object (e.g., a directory) will have to be recalled, and the individual
variables then accessed in the screen.
Purging an object from the SD card
To purge an object from the SD card onto the screen, use function PURGE, as
follows:
• In algebraic mode:
Press I @PURGE, type the name of the stored object using port 3 (e.g.,
:3:VAR1), press `.
• In RPN mode:
Type the name of the stored object using port 3 (e.g., :3:VAR1), press
I @PURGE.
To Next Page
Loading...
Need help?
General
