EasyManuals Logo

HP 5120 EI Switch Series User Manual

HP 5120 EI Switch Series
304 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
57
<Switch> system-view
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ip address 192.168.1.70 255.255.255.0
[Switch-Vlan-interface2] quit
# Configure the IP address of VLAN-interface 3, through which the switch communicates with the server.
[Switch] interface vlan-interface 3
[Switch-Vlan-interface3] ip address 10.1.1.2 255.255.255.0
[Switch-Vlan-interface3] quit
# Enable the switch to provide Telnet service.
[Switch] telnet server enable
# Configure the switch to use AAA for Telnet users.
[Switch] user-interface vty 0 4
[Switch-ui-vty0-4] authentication-mode scheme
[Switch-ui-vty0-4] quit
# Use HWTACACS authentication for user level switching authentication and, if HWTACACS
authentication is not available, use local authentication.
[Switch] super authentication-mode scheme local
# Create an HWTACACS scheme named hwtac.
[Switch] hwtacacs scheme hwtac
# Specify the IP address for the primary authentication server as 10.1.1.1 and the port for authentication
as 49.
[Switch-hwtacacs-hwtac] primary authentication 10.1.1.1 49
# Set the shared key for authentication packets to expert.
[Switch-hwtacacs-hwtac] key authentication expert
# Configure the scheme to remove the domain names in usernames before sending usernames to the
HWTACACS server.
[Switch-hwtacacs-hwtac] user-name-format without-domain
[Switch-hwtacacs-hwtac] quit
# Create ISP domain bbb.
[Switch] domain bbb
# Configure the ISP domain to use local authentication for Telnet users.
[Switch-isp-bbb] authentication login local
# Configure to use HWTACACS scheme hwtac for privilege level switching authentication.
[Switch-isp-bbb] authentication super hwtacacs-scheme hwtac
[Switch-isp-bbb] quit
# Create a local Telnet user named test.
[Switch] local-user test
[Switch-luser-test] service-type telnet
[Switch-luser-test] password simple aabbcc
# Configure the user level of the Telnet user to 0 after user login.
[Switch-luser-test] authorization-attribute level 0
[Switch-luser-test] quit
# Configure the password for local privilege level switching authentication to 654321.
[Switch] super password simple 654321

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5120 EI Switch Series and is the answer not in the manual?

HP 5120 EI Switch Series Specifications

General IconGeneral
BrandHP
Model5120 EI Switch Series
CategorySwitch
LanguageEnglish

Related product manuals