12
Figure 9 Mounting an HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch by the front
mounting position
Figure 10 Mounting an HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch by the
rear mounting position
Figure 11 Mounting an HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch by the
mid-mounting position
Mounting the switch on a workbench
IMPORTANT:
• Ensure 10 cm (3.9 in) of clearance around the chassis for heat dissipation.
• Do not place heavy objects on the switch.
If a standard 19-inch rack is not available, you can place you switch on a workbench.
To mount the switch on a workbench:
1. Verify that the workbench is sturdy and correctly grounded.
2. Place the switch with bottom up, and clean the round holes in the chassis bottom with dry cloth.
To Next Page
Loading...
