14
b. Attach the grounding screw to the ring terminal of the grounding cable.
c. Use a screwdriver to fasten the grounding screw into the grounding screw hole.
Figure 13 Connecting the grounding cable to the grounding hole of the switch
(1) Chassis rear panel (2) Groundin
si
n
(3) Grounding hole (4) Ring terminal
(5) Groundin
cable (6) Groundin
screw
2. Connect the other end of the grounding cable to the grounding strip.
a. Cut the grounding cable to a length according to the distance between the switch and the
grounding strip.
b. Peel 20 mm (0.79 in) of insulation sheath by using a wire stripper.
c. Use the needle-nose pliers to bend the bare wire.
d. Hook the grounding cable to the post on the grounding strip, and use the hex nut to secure the
cable to the post.
Figure 14 Connecting the grounding cable to a grounding strip
(1) Groundin
post (2) Groundin
strip
(3) Groundin
cable (4) Hex nut
To Next Page
Loading...
