HP 5130-24G-4SFP+ EI - Page 53

51
Switch model
Port mode
LED (Mode)
status
Status Description
green (PoE
mode)
Flashing green
(3 Hz)
• The PD power requirement exceeds the port
PoE capacity.
• The port fails to meet the power requirement of
the PD because of power insufficiency of the
switch.
Steady yellow
A non-PD device is attached to the port, or the port
is experiencing a PoE failure.
Flashing yellow
(3 Hz)
POST has failed on the port.
Off The port is not supplying PoE.
T h e H P 513 0 -24 G - 4 S F P + E I , H P 513 0 -24 G - 4 S F P + E I TA A , H P 513 0 -24 G - Po E + - 4 S F P + ( 370 W ) E I , a n d H P
5130-24G-PoE+-4SFP+ (370W) EI TAA switches provide two single-color LEDs for each
10/100/1000Base-T Ethernet port to indicate their operating status. When one of the two LEDs is on, the
other is off.
Table 21 10/100/1000Base-T Ethernet port LED description for HP 5130-24G-4SFP+ EI/HP
5130-24G-4SFP+ EI TAA, and HP 5130-24G-PoE+-4SFP+ (370W) EI/HP 5130-24G-PoE+-4SFP+
(370W) EI TAA switches
Switch model
Port mode
LED (Mode)
status
LED Status Description
• HP 5130-24G-4SFP+
EI
• HP 5130-24G-4SFP+
EI TAA
N/A
Green LED
Steady on
The port is operating at 1000
Mbps, and a link is present on
the port.
Flashing
The port is sending or receiving
data at 1000 Mbps.
Off
No link is present on the port, or
the port is not operating at
1000 Mbps.
Yellow LED
Steady on
The port is operating at 10/100
Mbps, and a link is present on
the port.
Flashing (not 3
Hz)
The port is sending or receiving
data at 10/100 Mbps.
Flashing yellow
(3 Hz)
POST has failed on the port.
Off
No link is present on the port, or
the port is not operating at
10/100 Mbps.
• HP
5130-24G-PoE+-4S
Steady
green (rate
mode)
Green LED Steady on
The port is operating at 1000
Mbps, and a link is present on
the port.