HP 6000 SERIES User Manual

3
3.5-inch Hard Disk Drive Installation
The following paragraphs describe how to install a 3.5-inch hard disk drive into
your mass storage system.
Your mass storage system can contain up to five
3.5-inch
hard disk drives.
Note
3.5-inch hard disk drives can be installed into any slot.
Although
it is a half-height device, only one 3.5-inch hard disk
drive can be installed in slot 2 (the rear slot). The first 3.5-inch
hard disk drive should be installed in slot 2 (rear slot) if it is
empty. This leaves the front slots open for devices
that might
require front panel access.
Unpacking the Upgrade Kit
Unpack and identify the contents of the upgrade kit. Figure 3-1 shows the
contents of the 3.5-inch hard disk drive upgrade kit.
Note
If you are installing a second (or two) 3.5-inch hard disk drives,
you will have an
extra mounting bracket.
3.5·inch Hard Disk Drive Installation 3·,

HP 6000 SERIES Specifications

General

Brand	HP
Model	6000 SERIES
Category	Storage
Language	English