HP 6125G - Upgrading the System Software

To Next Page

To Previous Page

Now updating bootrom, please wait...

Bootrom successfully updated!

# Perform the save command to save the current configuration.

<Sysname> save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

flash:/startup.cfg exists, overwrite? [Y/N]:y

Validating file. Please wait.................

The current configuration is saved to the active main board successfully.

Slot 2:

The current configuration file is saved successfully.

Configuration is saved to device successfully.

# Reboot the IRF fabric to complete the upgrade.

<Sysname> reboot

Start to check configuration with next startup configuration file, please wait.

........DONE!

This command will reboot the device. Continue? [Y/N]:y

Reboot device by command.

Upgrading the system software

To upgrade the system software by using the boot-loader command:

1. Perform the copy command to copy the system software image file newest.bin from the master to

the root directory of the storage media on the subordinate with the number 2. Make sure to save

the system software image to the root directories of the storage media of all member switches.

<Sysname> copy newest.bin slot2#flash:/

Copy flash:/newest.bin to slot2#flash:/newest.bin?[Y/N]:y

%Copy file flash:/newest.bin to slot2#flash:/newest.bin...Done.

2. Perform the boot-loader command in user view to load the file newest.bin and specify the file as

the main image file at the next reboot.

<Sysname> boot-loader file newest.bin slot all main

This command will set the boot file of the specified board. Continue? [Y/N]:y

The specified file will be used as the main boot file at the next reboot on slot

3. Save the current configuration in any view to prevent data loss.