HP 6125G - Table 15 Bootware Operation Menu Options

35
============================================================================
Enter your choice(0-4):
Table 15 BootWare Operation menu options
Option
Tasks
<1> Backup Full BootWare
Back up the entire BootWare image. When the BootWare
image is corrupted, you could use the backup image for
recovery.
<2> Restore Full BootWare
Recover the entire BootWare image.
If the BootWare image has been corrupted, you can use a
backup BootWare image to recover it.
<3> Update BootWare By Serial
Update the BootWare from the console port.
<4> Update BootWare By Ethernet
Update the BootWare from an Ethernet port.
<0> Exit To Main Menu
Return to the EXTEND-BOOTWARE menu.
Clearing all user privilege passwords
IMPORTANT:
 To perform this task, make sure password recovery capability is enabled. If the capability is disabled,
you cannot perform this task.
 Clearing user privilege passwords applies only to console login users. All other types of users such as
Telnet users must always provide the password to switch to a higher password-protected user privilege.
 Clearing user privilege passwords is a one-time operation. It takes effective only for the first system boot
or reboot (option 1 and option 0 in the EXTEND-BOOTWARE menu) after you perform the operation.
If you do not change the user privilege password settings, the original settings continue to take effect on
console login users for the subsequent reboot.
Each user privilege is assigned the right to access a set of commands. You can configure a password with
the super password command to protect a user privilege. To switch to a password protected user
privilege from a lower privilege for accessing higher level commands, a user must provide the correct
password.
If you cannot remember the passwords, enter 8 in the EXTEND-BOOTWARE menu to have the system
start up with the next-startup configuration file with all user privilege passwords ignored.
Enter your choice(0-9): 8
Clear Application Password Success!
Managing storage media
To get information about available storage media, and set the storage medium you want to use for file
operations, enter 9 in the EXTEND-BOOTWARE menu.
Enter your choice(0-9): 9
The following DEVICE CONTROL menu appears:
==============================<DEVICE CONTROL>==============================
|<1> Display All Available Nonvolatile Storage Device(s) |
|<2> Set The Operating Device |