42
|<2> Update Main Application File |
|<3> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|<Ensure The Parameter Be Modified Before Downloading!> |
============================================================================
Enter your choice(0-3):
7. Enter 0 to return to the BootWare menu or 1 to boot the system.
Using Xmodem through the console port
1. Connect the console port of the switch to the PC that stores the .bin file.
2. Run the terminal emulation program on the PC. Start the switch, enter the boot menu (see
Accessing the BootWare menu for more information).
3. Enter 2 in the BootWare menu to access the Serial submenu.
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-3):
Table 22 Serial submenu options
4. Enter 3 to set the XMODEM download baudrate.
===============================<BAUDRATE SET>===============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------<Baudrate Available>---------------------------|
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200 |
|<0> Exit |
============================================================================
Enter your choice(0-5):
5. Select an appropriate baudrate for the console port. For example, enter 5 to select 115200 bps.
Baudrate has been changed to 115200 bps.