HP 6125G - Table 23 Network Parameter Fields and Shortcut Keys

48
Table 23 Network parameter fields and shortcut keys
Field
Description
'.' = Clear field
Press a dot (.) and then Enter to clear the setting for a field.
'-' = Go to previous field
Press a hyphen (-) and then Enter to return to the previous field.
Ctrl+D = Quit
Press Ctrl + D to exit the Ethernet Parameter Set menu.
Protocol (FTP or TFTP)
Set the file transfer protocol to FTP or TFTP.
Load File Name
Set the name of the file to be downloaded.
Target File Name
Set a file name for saving the file on the switch. By default, the target
file name is the same as the source file name.
Server IP Address
Set the IP address of the FTP or TFTP server. If a mask must be set, use
a colon (:) to separate the mask length from the IP address. For
example, 192.168.80.10:24.
Local IP Address
Set the IP address of the switch.
Gateway IP Address
Set a gateway IP address if the switch is on a different network than
the server.
7. Select an option in the Ethernet submenu to upgrade a system software image. For example, enter
1 to upgrade the main system software image.
Loading.....................................................................
............................................................................
.........................................Done!
17163940 bytes downloaded!
Updating Basic BootWare? [Y/N]
8. Enter Y at the prompt to upgrade the basic BootWare section.
Updating Basic BootWare.........Done!
Updating Extend BootWare? [Y/N]
9. Enter Y at the prompt to upgrade the extended BootWare section.
Updating Extend BootWare.........Done!
===================<BOOTWARE OPERATION ETHERNET SUB-MENU>===================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
10. Enter 0 in the BootWare update menu to return to the BootWare submenu.
11. Enter 0 in the BootWare submenu to return to the BootWare menu.
12. Enter 0 in the BootWare menu to reboot the switch with the new BootWare image.