29
Table 12 Ethernet submenu options
<1> Download Application Program To SDRAM
And Run
Load and run a system software image in SDRAM.
If password recovery capability is disabled, this option is
not available.
<2> Update Main Application File
Download a system software image to the current storage
medium as the main image (the file attribute is set to M).
If a main system image already exists, the M file attribute of
the original image is removed.
<3> Modify Ethernet Parameter
Configure FTP or TFTP file transfer settings.
Return to the EXTEND-BOOTWARE menu.
2. Enter 3 in the Ethernet submenu to configure file transfer settings.
Enter your choice(0-3):3
=================================<ETHERNET PARAMETER SET>===================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
============================================================================
Protocol (FTP or TFTP) :tftp
Load File Name :test.bin
:
Target File Name :test.bin
:
Server IP Address :192.168.0.23
Local IP Address :192.168.0.93
Gateway IP Address :0.0.0.0
Table 13 Setting file transfer parameters
Press the dot (.), and then press Enter to clear the setting for a field.
'-' = Go to previous field
Press the hyphen (-), and then press Enter to return to the previous field.
Press Ctrl + D to exit the Ethernet parameter settings menu.
Set the file transfer protocol to FTP or TFTP.
Set the name of the file to be downloaded.
Set a file name for saving the file in the current storage medium on the
device. The target file name must have the same suffix as the source
file.
By default, the target file name is the same as the source file name.
Set the IP address of the FTP or TFTP server. If a mask must be set, use
a colon (:) to separate the mask length from the IP address. For
example, 192.168.2.26:24.
Set the IP address of the device.
To Next Page
Loading...
