HP 6125G - Table 20 Ethernet Submenu Options

40
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|<Ensure The Parameter Be Modified Before Downloading!> |
============================================================================
Enter your choice(0-3):
7. Enter 0 to return to the BootWare menu or 1 to boot the system.
Using FTP through the management Ethernet port
1. Connect the management Ethernet port of the switch to the PC that stores the target .bin file (the IP
address of the PC is required), and connect the console port of the switch to the same or another
PC.
2. Run the FTP server program on the PC connected to the management Ethernet port, specify the file
storage directory, and set the username and password.
NOTE:
The HP 6125 Blade switches are not shipped with FTP server software. Prepare it yourself.
3. Run the terminal emulation program on the PC connected to the console port. Start the switch, enter
the BootWare menu (see Accessing the BootWare menu for more information).
4. Enter 3 in the BootWare menu to access the Ethernet submenu.
=========================<Enter Ethernet SubMenu>=========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|<Ensure The Parameter Be Modified Before Downloading!> |
==========================================================================
Enter your choice(0-3):
Table 20 Ethernet submenu options
Item
Description
<1> Download Application Program To SDRAM And
Run
Download a system software image to the SDRAM
and run the image.
<2> Update Main Application File
Upgrade the main system software image.
<3> Modify Ethernet Parameter
Modify network settings.
<0> Exit To Main Menu
Return to the BootWare menu.
5. Enter 5 to configure the network settings.
======================<ETHERNET PARAMETER SET>==============================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |