239
Ste
Command
Remarks
3. Enable BGP route refresh for a
peer or peer group.
• Enable BGP route refresh for the
specified peer or peer group:
peer { group-name |
ip-address }
capability-advertise
route-refresh
• Enable BGP route refresh and
multi-protocol extension
capability for the specified peer
or peer group:
undo peer { group-name |
ip-address }
capability-advertise
conventional
Use either method.
By default, BGP route refresh is
enabled.
To enable BGP route refresh for a peer or peer group (IPv6):
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enable BGP route refresh for a
peer or peer group.
• Enable BGP route refresh for the
specified peer or peer group:
peer { group-name |
ipv6-address }
capability-advertise
route-refresh
• Enable BGP route refresh and
multi-protocol extension
capability for the specified peer
or peer group:
undo peer { group-name |
ipv6-address }
capability-advertise
conventional
Use either method.
By default, BGP route refresh is
enabled.
Saving updates
To save all route updates from the specified peer or peer group (IPv4):
Ste
Command
Remarks
1. Enter system view.
system-view N/A
To Next Page
Loading...
