HP 6125XLG - Page 252

240
Ste
p
Command Remarks
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
address-family ipv4 [ unicast ] N/A
4. Save all route updates from
the peer or peer group.
peer { group-name | ip-address }
keep-all-routes
By default, the routes are not
saved.
This command takes effect only on
the routes received after this
command is executed.
To save all route updates from the specified peer or peer group (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view
bgp as-number
N/A
3. Enter BGP IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Save all route updates from
the peer or peer group.
peer { group-name |
ipv6-address } keep-all-routes
By default, the routes are not
saved.
This command takes effect only on
the routes received after this
command is executed.
Configuring manual soft-reset
To configure manual soft-reset (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A