HP 8153A - Page 116

Tkbie 6-1. Common Command Summary
Command Function
♦ CLS
Clear Status Command
*ESE
Standard Event Status Enable Command
*ESE?
Standard Event Status Enable Query
^ ♦ 'ESR?
Standard Event Status Register Query
^IDM? Identification Query
x^QPC
Operation Complete Command
*DPC?
Operation Complete Query
*RST Reset Command
+SRE
Service Request Enable Command
*SRE?
Service Request Enable Query
=^STB? Read Status Byte Query
*TRG Trigger Command
*TST? Self Test Query
=^=WAI Wait Command
*CLS
CLear Status command.
Syntax *CLS
Definition The *CLS command clears all the event registers
summarized in the Status Byte register. With the
exception of the output queue, all queues that are
summarized in the Status Byte register are emptied. The
error queue is also emptied. Neither the Standard Event
Status Enable register, nor the Service Request Enable
register are affected by this command.
After the *CLS command the instrument is left in the idle
state. The command does not alter the instrument setting,
*0PC/*0PC? actions are canceled.
Related Command Interface Command SDC
6-4 Remote Operation - Common Commands