HP 8153A - Page 122

Definition
Related Commands
Example
*RST
ReSeT command.
Syntax
Definition
channel A, the second string returns the module in
channel B. EMPTY is returned if a slot contains no
module.
The *0PT? query gets the instrument to identify its
installed options over the interface.
DIM A$ [20]
OUTPUT 722;"*0PT?"
EMTER 722; A$
If the installed modules were a HP 81554SM and a HP
8i530A, the returned string would be HP815S4SM,HP
81530A.
*RST
The *RST command sets the instrument to reset setting
(standard setting) stored in ROM.
Pending *OPC/*DPC? actions are canceled.
Instrument state: the instrument is placed in the idle
state awaiting a command.
The *RST command clears the key queue.
The following are not changed:
■ HP-IB (interface) state
■ Instrument interface address
■ Output queue
■ Service Request Enable register (SRE)
■ Standard Event Status Enable register (ESE)
The following table lists the commands and parameters of
the reset state.
6-10
Remote Operation • Common Commands