HP 8153A - Page 133

Example OUTPUT 722; "STAT: OPER:TRIG:POW: COMD?"
ENTER 722 ;A$
STATUS: <no<ie> lENABle
Syntax STATus;<node>:ENABle <value>
0 < value < 32767
Description This command sets the enable register for the node. You
send the value as an integer (NRf). A 1 in any bit of this
register enables that bit in the event register. All the
enabled bits are ORed together and the result of this OR is
sent to the next node.
Related Commands STAT:<node>:ENAB?
Example OUTPUT 722; "STAX: OPER:TEIG:POW:EWAB 3"
STATus:<node>:ENABle?
Syntax STATus:<node>:EMABle?
Response <value>
0 < value < 32767
Description This query returns the setting for the enable register for
the node. The value is returned as an integer (NRl).
Related Commands STAT: <node>: ENAB
Example OUTPUT 722; "STAT;qUES:POU:EMAB?"
ENTER 722 ;A$
STATus;<iiode>[:EVENt]?
Syntax STATus: <node> [: EVENt]?
Response <value>
0 < value < 32767
Description This query returns the value for the event register for the
node. The value is returned as an integer (NRl). Once
you have read the event register, its contents are cleared.
Remote Operation - Status Commands 7-5