HP 8153A - Page 137

The Operation Status Commands
The following is a complete list of the operation status commands and queries.
These commands and queries are available, without regard to the conllguration
of the instrument. Some nodes are only active with certain modules. For
example, the averaging registers are not used if the instrument has two source
modules. Here, you can read the averaging event register, but it always returns
aO.
'Ikble 7-1. STATUS Command Summary
_ Command _ Parameter
t is being used as shorthand for
:C0NDition?
lENABle
:EHABle? <value>
[:EVEMt3?
iMTRansition <value>
:MTRansition?
_ :PTRansition _ <value>
STATUS
lOPERation t
:SETTling t
:LPELTier |
:HPELTier J
:MEASuring |
:P0Wer $
:TRIGger $
:P0Wer t
:CORRecting $
:ZER0 t
:AVERaglng t
:power J
:PR0Gram J
:<application> J
Remote Operation • Status Commands 7-S