HP 8153A - Page 153

Description
Related Commands
Example
DISPlay:STATe
Syntax
Description
Related Commands
Example
DISPlay:STATe?
Syntax
Response
Description
Related Commands
Example
This command returns the brightness of the display. The
brightness can be within the range 0 to 1. Where 0 means
that the display is at it’s lowest intensity, and 1 that it is
full intensity.
DISP:BRIG, DISP:STAT,DISP:STAT?
OUTPUT 722;"DISP:BRIG?"
ENTER 722 ;A$
DISPlay[:STATe] <wsp><boolean>
This command switches the display on or olT.
DISP:STAT OK switches the display on.
DISP:STAT OFF switches the display olT.
The default (for example, after a *RST command) is for
the display to be on.
DISP:BRIG, DISP:BRIG?,DISP:STAT?
OUTPUT 722 ; "DISP : STAT OK"
Display! :STATe]?
<boolean>
This command returns the state of the display. 0 means
that the display is off. 1 means that the display is on.
DISP:BRIG, DISP:BRIG?, DISP;STAT
OUTPUT 722; "DISP; STAT? "
ENTER 722 ;A$
Remote Operation - Commands 8-3