HP 8153A - Page 162

Description This command enters a calibration factor for the module.
The value is a floating point number (NRf). The units are
dB. dB are the units used if you do not specify units. /
Related Commands SEWS:CORE:CQLL:LOSS:INP:MAGK?
Example OUTPUT 722; '’SEKS2: CORK: COLL: LOSS: INP:MAGN lODB"
SENSe:CORRectioii[;LOSS[:INPut[:MAGNitude]]]?
Syntax SEHSeflj2]:CORRection”[: LOSS[: IWPut[: HAGMitude]]]?
Response <value>
Description This command returns the calibration factor. The factor is
returned as a floating point number (NR3) in dB. No units
are returned in the response message.
Related Commands SEKS: CORE: COLL: LOSS: INP: MAGN
Example OUTPUT 722; "SEMS2:CORE: COLL:LOSS: INP:MAGN?
ENTER 722 :A$
SENSe:POWer:ATIME
Syntax SENSe[l|2]:POWer;ATIME” <wsp><va!ue>[<unit>l
20ms < value < 3600s
unit is S|MS
Description This command sets the averaging time for the module.
The input power-level is read and averaged over this
period. You specify the averaging time as a floating point
number (NRf). Units can be attached, either seconds or
milliseconds can be specified. Seconds are the units used
if you do not specify units.
Related Commands SENS: POW: ATIME?
Example OUTPUT 722;"SENS:POW:ATIME 200MS"
8-12 Remote Operation-Commands