HP 8153A - Page 163

SENSe:POWer:ATIME?
SENSe[l|2]:P()Wer:ATlME?”
<value>
20ms < value < 3600s
This command returns the setting for the averaging time
for the module. The averaging time is returned as a
number in exponential number (NR3). The returned
value is in seconds. No units are returned in the response
message.
Related Commands SENS: POW; ATIME
Example OUTPUT 722;"SEMS2:POW:ATIME?"
ENTER 722 ;A$
SENSe:POWer:RANGe:AUTO
Syntax SENS6[l|2]:P0Wer:RANGe:AUT0'’ <wsp><boolean>
Description This command enables or disables automatic power
ranging for this module. That is whether the ranging is set
by the POW:RANG command, or whether it is automatically
determined by the instrument. You specify the ranging by
a boolean. OFF, or 0, disables automatic ranging. ON, or
any non-zero value, enables automatic ranging.
Related Commands SENS:POW:RANG:UPPER, SENS:PQW:RANG:UPPER?,
SENS:POW:RANG:AUTO?
Example OUTPUT 722C‘SENS1 :P0W:RANG: AUTO OFF"
SENSe;POWer:RANGe:AUTO?
Syntax SEKSe[ii2];POWer:RANGe:AUTO?”
Response <boolean>
Description This command returns whether automatic power ranging
is being used by the module. The ranging is returned
as either 0 or 1. 0 means that automatic ranging is not
selected. 1 means that automatic ranging is selected.
Syntax
Response
Description
Remote Operation • Commands 8-13