HP 8153A - Page 164

Related Commands SEHS:POW:RAHG:UPPER, SENS:POW:RAMG;UPPER?,
SENS;PDW:RANG:AUTO
Example OUTPUT 722; "SEWS2 :POW:RANG: AUTO?"
ENTER 722 ;A$
SENSe:POWer:RANGe[:UFPEIl]
Syntax SENS6[l!2];P0Wer:RANGe[:UPPER]’'
<wsp><value>[<unit>]
-llOdBm < value < +30dBm. The actual limits depend on
the module you use, please refer to the specifications for
you module in Appendix C.
unit is DBM
Description This command sets the power range for this module, that
is the full-scale value for the display. The range changes
at lOdBm intervals. The corresponding ranges for linear
measurements (measurements in Watts) are given in the
table below:
8-14 Remote Operation ■ Commands