HP 8153A - Page 169

Related Commands SENS:P0W:REF, SENS:POW:REF?, SENS:POW:REF:STATE,
SENS:POW:REF;STATE?, SENS:PDW:REF:STAT:RATI.
SENS:POW:REF:STAT:RATI?
Example OUTPUT 722; "SENS:POW:REF TQREF"
OUTPUT 722: "SENS: POW: REF: DISP"
SENSe:POWer;REFerence:STAlte
Syntax SENSe[lj2j:FOWer:REFerence:STATe” <wsp><boolean>
Description This command sets whether the rCvSnlts are in relative
or absolute units. The reference state is specified by a
boolean. OFF, or 0, means that the result is absolute (that
is, in dBm or Watts). ON, or any non-zero value, means
that the result is relative to a reference level (that is, in
dB).
Related Commands SENS:POW:REF, SENS:POW:REF?, SENS:POW:REF:STATE?,
SENS:POW:REF:STATE:RATI, SENS:POW:REF:STAT:RATI?,
SENS:POW:REF:DISP, SENS:POW:UNIT, SENS:PDW:UNIT?
Example OUTPUT 722;"SENS1:POW:REF:STATE ON"
SENSe:POWer:REFerence:STAlte?
Syntax SENSe[l|2]:P0Wer:REFerence:STATe?”
Response <boolean>
Description This command returns whether the results are in relative
or absolute units. The ranging is returned as either 0 or 1.
0 means that the results are absolute (that is, in dBm or
Watts). 1 means that the result is relative to a reference
(that is, in dB).
Related Commands SENS:PQW:REF, SENS:POW:REF?, SENS:POW:REF:STATE,
SENS:POW:REF:STATE:RATI, SENS:POW:REF:STAT:RATI?,
SENS:POW:REF:DISP, SENS:POW:UNIT, SENS:POW:UNIT?
Example OUTPUT 722; "SENSl:POW:REF:STAT?"
ENTER 722 ;A$
Remote Operation • Commands 8-19