HP 8153A - Page 170

SENSe:POWer:REFerence:STATe:RATIo
SENSe[i|2]:POWer:REFerence:STAl^:RATIo”
<wsp>T0A!T0BjT0REFi0|i|2
This command selects the reference with respect to which
the results for this module arc given. That is whether
the results are displayed relative to channel A TOA (or 0),
relative to channel B TOB (or 1), or relative to an absolute
reference TOREF (or 2). TOB (or 1) is only possible for
channel A of an instrument that has a sensor in each
channel. TOA (or 0) is only possible for channel B of an
instrument that has a sensor in each channel.
Related Commands SEWS:POW;REF, SENS:P0W:REF?, SENS:P0W:REF:STATE,
SENS:POW:REF:STATE?,SENS :P0W:REF:STAT:RATI?,
SENS:PON:REF:DISP
Example OUTPUT 722; "SENS2: POW :REF: STAT: RATI TOB”
SENSe:POWer:REFereiice:STATe:RATIo?
Syntax SENSe[l|2]:POWer:REFerence:STATe:RATIo?”
Response 0jl|2
Description This command returns the reference setting for the
module. The ranging is returned as one of 0, i, or 2.
0 is returned if channel A is being used as a reference
for channel B. 1 is returned if channel B is being used as
a reference for channel A. 2 is returned if an absolute
reference is being used.
Related Commands SENS:POW:REF, SENS:POW:REF?, SENS:POW:REF :STATE,
SENS:POW:REF;STATE?,SENS :POW:REF:STAT:RATI.
SENS:POW:REF:DISP
8 Example OUTPUT 722; "SENS! ;PQW;REF :STAT:RATI?”
ENTER 722 ;A$
Syntax
Description
i
8-2Q Remote Operation • Commands