HP 8153A - Page 171

SENSe:POWer:UNIT
Syntax SENSe[li21:P0Wer:UNIT” <wsp><iimt>
unit is DBM|Watt|0|l
Description This command sets the units in use when an absolute
reading is made. This can be dBm (DBM|0) or Watts
(Wattji).
Related Commands SEMS;POW;Um?, SEMSrPOW:REF:STATE,
SENS:P0W:REF:STATE?
Example OUTPUT 722; '*SEMS1 :POW: UNIT W"
SENSe:POWer:UNIT?
Syntax SENSe[l|2]:POWer:UNrr?”
Response <unit>
Description This command returns the units selected for absolute
readings. 0 means that dBm is being used as the absolute
units. 1 means that Watts are being used as the absolute
units.
Related Commands SENS:P0W:UNIT, SENS:PQW:REF:STATE,
SENS:P0W:REFrSTATE?
Example OUTPUT 722;'’SENS2:P0W:UNIT?”
ENTER 722 ;A$
SENSe:POWer:WAVElength
Syntax SENSe|lj2]:POWer;WAVEiength” <wsp><va]ue>[<unit>]
450nm < value < ITOOnm. The actual limits depend on
the module you use, please refer to the specifications for
you module in Appendix C.
unit is NM|UM|M
Description This command sets the wavelength for this module. You
specify the wavelength as a floating point number (NRf).
The units can be nanometers, micrometers or meters.
Meters are the units used if you do not specify units.
Remote Operation • Commands 8-21