HP 8153A - Page 186

■ varname = THRESHOLD, this is the threshold level for
stiirting. It is only applicable when LOGGSTART is set to
1 or 2.
Note Do not specify units for this parameter
-400 < value < 400
The value for the threshold level is in dBm.
The other parameters (such as T^vg and wavelength) must
be set with a SENSe command.
Results ■ varname = ASAMPLES, the number of samples taken.
■ varname = RESULT, the logged values. This is returned
as a string of values separated by commas (,), or as an
array of values, depending on the controlling program.
The Stability Application
application STABILITY
Note
This application only runs on an instrument with a sensor
module.
Parameters ■ varname T.TOTAL, this is the total time for which
the application is to be run. The difference of the
actual total time from T_T0TAL depends on a number of
factors including the system configuration. The worst
case timing difference is 30s/h.
0 < value < 359,999
value is the total time in seconds.
The other parameters (such as T^vg and wavelength) must
be set with a SENSe command.
Results ■ varname = ASAMPLES, the number of samples taken.
9-6 Remote Operation - Application Commands