HP 8153A - Page 185

Mainframe Applications
These are applications that are supplied with the software of the mainframe.
For more complete explanation of the application, refer to Chapter 3
The Logging Application
application LOGGING
Note
This application only runs on an instrument with a sensor
module.
Parameters ■ varname = SAMPLES, this is the number of samples to
be taken.
1 < value < 500
The total time for the logging application consists of the
averaging time and the time to process the sample. That
is, a sample is only taken after the previous sample has
been taken and processed.
The processing time depends on a number of factors
including the system configuration. If any applications
or measurements are running in the other channel, the
processing time between samples may vary.
On printer or plotter outputs, the total time given for
the logging application includes both the averaging and
the processing time.
■ varname = LOGGSTART, this is the starting condition,
value = li2!3 where
1 means start when the input power-level is above
threshold.
2 means start when the input power-level is below
threshold.
3 means start immediately.
Remote Operation - Application Commands 9-5