HP 8153A - Page 266

-178 Expression data not allowed.
Execution Errors
These error codes are in the range -299 to -200. They indicate that an error has
been detected by the part if the instrument that controls command execution.
■ Data is out of range.
■ The command could not be executed because of hardware limitations.
The Execution Error bit is set in the Event Status Register, see “*ESR?” in
Chapter 6.
-200 Execution error [generic].
-201 Invalid while in local [only available in remote, otherwise conflict with
hard local-control may result].
-202 Settings lost due to ???
-210 Trigger error.
-211 Trigger ignored [new trigger received before old data read]
-212 Arm ignored.
-213 Init ignored.
-214 Trigger deadlock.
-215 Arm deadlock.
-220 Parameter error.
-221 Settings conflict [uncoupled parameters].
-222 Data out of range [e.g. wavelength too high for this instrument].
-223 Tbo much data [out of memory; block, string, or expression too long].
-224 Illegal parameter value [used where exact value, from a list of
possibles, was expected].
-230 Data corrupt or stale [possibly invalid data; new reading started but
not completed since last access].
-231 Data questionable [measurement accuracy is suspect].
-240 Hardware error.
-241 Hardware missing [option not installed].
1-6 Error Codes