HP 8153A - Page 267

-260 Expression error.
•261 Math error in expression [e.g., divide by zero]
-280 Program error,
-281 Cannot create program.
-282 Illegal program name.
-283 Illegal variable name.
-284 Program currently running.
-285 Program syntax error.
-286 Program runtime error.
Device Dependant Errors
These error codes are in the range -399 to 300. They indicate a failure due to
an abnormal hardware or firmware condition. These codes are also used for
the results of the self-test. The Device Dependant Error bit is set in the Event
Status Register, see “*ESR?” in Chapter 6.
-300 Device dependent error [generic failure message].
-310 System error.
-311 Memory error [this message, or any in the range -319 to -310, may be
generated by checksum or parity errors].
-312 Protected user data memory lost [data no longer available].
-313 Calibration memory lost [out of calibration due to memory failure].
-314 Save/Recall memory lost [cannot complete *RCL request].
-315 Configuration memory lost.
-330 Self-test failed [more specific data after
-350 4bo many errors (more than 30) [error queue overflow).