HP 8153A - Page 89

DELTA
When you select this parameter, the left side character field shows the message
DELTA. The right side character field shows the value for the delta.
■ You edit the delta using the Modify keys. The lower limit is O.OldB. The
higher limit is IS.OOdB. The displayed value is always the setting for the delta.
■ You can press (Mtl if you have finished editing, or you can press or fpj^
to edit the other parameters.
MAXPOWEK
You can only select this parameter when TYPE is set to MANUAL. When you select
this parameter, the left side character field shows the message MAXPOWER. The
right side character field shows the setting for the maximum power.
■ You edit the maximum power using the Modify keys. The lower limit is
-400.00dBm. The higher limit is 400.00dBm. The displayed value is always
the setting for the maximum.
■ You can press (Edit) if you have finished editing, or you can press (n^ or (p^
to edit the other parameters.
Running the Alignment Application
To run the application, press (Exec) . You cannot run the application if
you are editing parameters. While the application is running, the RUM
operation-indicator lights.
While the application is running, the left side result field shows the maximum
power-level. If TYPE is set to AUTO, the maximum power-level is the maximum
input power-level read since the application started. If TYPE is set to MANUAL,
the maximum power-level is set by MAXPOWER. The right side result field shows
the input power-level, in dB, relative to the maximum power-level.
Local Control • Menu Mode 3-25