5-36
Status Listings
OSA Errors
20005 desc = “Trans-Impedance calibration data is invalid”
help = “Factory calibration data for the trans-impedance amplifier is invalid.
Please record the hexadecimal number listed with the error and cycle power. If
the error persists, contact the nearest Hewlett-Packard Instrument support
center for assistance. In the U.S., call (800) 403-0801. See the HP 86140 series
Users Guide for a listing of the HP sales and service offices.”
20006 desc = “Monochromator flatness calibration data is invalid”
help = “Factory flatness data for the monochromator is invalid. Please record the
hexadecimal number listed with the error and cycle power. If the error persists,
contact the nearest Hewlett-Packard Instrument support center for assistance.
In the U.S., call (800) 403-0801. See the HP 86140 series Users Guide for a
listing of the HP sales and service offices.“
20007 desc = “Sweep Timeout”
help = “A sweep was started but did not finish in the expected amount of time.
The trace data acquired during this sweep may not be valid. Try taking another
sweep. If the error persists, contact the nearest Hewlett-Packard Instrument
support center for assistance. In the U.S., call (800) 403-0801. See the HP 86140
series Users Guide for a listing of the HP sales and service offices.”
21999 desc = “The Error list has overflowed”
help = “The Error list has overflowed. The last entries received have been
deleted.”
Table 5-9. OSA Errors (2 of 2)
Error Number Error Description [description/explanation/examples]
book.book Page 36 Monday, January 31, 2000 10:34 AM
To Next Page
Loading...
Need help?
General
