Automating Measurements 8-3
Saving Measurement Results
Querying Measurement Data
Querying Measurement Data
To save the complete measurement trace, use the SCPI command:
CALC1:DATA?
or
TRACE1:DATA? CH1FDATA
Refer to the chapter titled “Trace Data Transfers” in the Programmer's
Guide for more details.
From IBASIC, you can also use the subprogram “Read_fdata( )”, which is
faster. Refer to the chapter titled “Using Subprograms” in the HP
Instrument BASIC User’s Handbook Supplement.
To Next Page
Loading...
