HP 8712ES - Using both of the Analyzers Measurement Channels

Automating Measurements 5-11
Automated Measurement Setup and Control
Using Both of the Analyzer's Measurement Channels
Using Both of the Analyzer's
Measurement Channels
The analyzer is capable of making different measurements on each of its
two measurement channels. For example, you can set measurement
channel 1 to measure transmission over one set of sweep frequencies,
while measurement channel 2 is set to measure reflection over another
set of sweep frequencies. Thus, two measurements can be made by the
operator at the same time. Also, the controller can switch between
measurement channel 1 and measurement channel 2, while turning the
inactive channel off, to quickly change the test setup between two test
states.