Automating Measurements 4-3
Measurement Setup and Control with Fast Recall
Using Fast Recall with the Front Panel or a Keyboard
Using Fast Recall with the Front Panel
or a Keyboard
NOTE The following explanation assumes that you are familiar with the
information presented in “Saving and Recalling Measurement Results”
in Chapter 4 of your analyzer’s User’s Guide.
1. Press .
2. If the measurement display area changes to a listing of files on the
currently selected disk, fast recall is off.
If the measurement display area remains unchanged, fast recall is on.
To follow along with this explanation, turn fast recall off by pressing
so that “OFF” is capitalized.
3. If necessary, select the internal non-volatile RAM disk by pressing
.
4. If you have previously saved any files to this disk, they will now be
listed on the display.
5. The fast recall feature utilizes only the first seven files listed that
contain instrument state, calibration, or measurement data.
6. If you have not previously saved any files to this disk, you may want
to save a few instrument states now, to follow along.
7. Press so that “ON” is
capitalized. Note that the measurement display now reappears on the
screen and that there are file names next to the first seven softkeys.
(If any of the softkeys are blank, it's because you had less than seven
files saved on the disk.)
The files are placed on the softkeys in the order in which they appear
in the disk's directory table.
NOTE You may want to use the feature to give your files more
meaningful names. See “Other File Utilities” in Chapter 4 of your
analyzer’s User’s Guide for information on renaming files.
8. To “fast recall” an instrument state, press the softkey next to the file
name that contains the instrument state.
SAVE RECALL
To Next Page
Loading...
