HP 8712ES - Using Fast Recall with a Switch

Automating Measurements 4-5
Measurement Setup and Control with Fast Recall
Using Fast Recall with a Switch
Using Fast Recall with a Switch
When fast recall is used in conjunction with a switch connected to the
USER TTL IN/OUT rear panel connector, you can cycle through up to
seven instrument states in sequence by activating the switch.
1. Connect a switch to the USER TTL IN/OUT rear panel connector as
shown in Figure 4-1.
Figure 4-1 Connect a Switch to the USER TTL IN/OUT Connector
2. Make sure the analyzer is configured to use the USER TTL IN/OUT
connector for softkey sequencing: press
.
3. With toggled to ON, press the switch several times
while observing the analyzer.
4. Notice that with each press of the switch, the files are highlighted
(boxed) in succession, and that after the last available file has been
used, the sequence starts again at the top of the softkey menu.
SYSTEM OPTIONS
System Config
User TTL Config
Softkey Auto Step
Fast Recall