Automating Measurements 3-11
Operator Interaction
User-Defined BEGIN Key Menu
9. To verify your change, select
.
10.Select the first softkey which should be labeled “Setup 1”. This should
return you to your correct setup.
11.You may save this program as an AUTOST file or other file for later
recall.
Refer to the HP Instrument BASIC User’s Handbook Supplement.
Using a Switch with User BEGIN
When user-defined is used in conjunction with a switch
connected to the USER TTL IN/OUT rear-panel connector, you can cycle
through up to seven softkeys in sequence by activating the switch.
1. Connect a switch to the USER TTL IN/OUT rear panel connector as
shown in Figure 3-2.
Figure 3-2 Connecting a Switch to the USER TTL IN/OUT Connector
PRESET BEGIN
BEGIN
To Next Page
Loading...
