These 6 commands display the indicated combinations of data and trace
memory on the active channel:
DISPDATA
DISPDATM
DISPDDM
DISPDMM
DISPMEMO
DIVI
DONE
DONM
DOSEQ<I>
DOWN
DUAC<ONIOFF>
DUPLSEQ[X]SEQ[Y]
EDITDONE
EDITLIML
EDITLIST
ELED[D]
EMIB
ENTO
ESB?
Data only.
Data and memory.
Data divided by memory (linear division,
log subtraction).
Data minus memory (linear subtraction).
Memory only.
Same as DISPDDM.
Done with a class of standards, during a
calibration. Only needed when multiple
standards are measured to complete the
class.
Done modifying a test sequence.
Begins execution of the selected sequence.
Range: 1 to 6.
Decrements the value in the active entry
area (down key).
Dual channel display ON or OFF.
Duplicates sequence X to sequence Y.
Range X,
I?
1 to 6.
Done editing list frequency or limit table.
Begins editing limit table.
Begins editing list frequency table.
Sets the electrical delay offset.
Range:
f10
s.
Sends out a beep during a sequence.
Turns the active entry area OFF.
Outputs event-status register B.
l-l 14 HP-IB
Progr
amming and Command Reference Guide
To Next Page
Loading...
