HP 8753E - HP-IB Only Commands

HP-IB Only Commands
Table l-11. HP-IB Only Commands
Action
Mnemonic S ? Description
INPUT
:rror
INPUCALC<Ol, 2
Inputs an individual error coefficient array.
oefflcient 02,. . . 12>
Issue the command CALIxxxX;(XXXX specifies
the data calibration type), then input each of
the appropriate individual error coefficients
using INPUCALC. Finally, issue SAVC; and
trigger a sweep.
SAVC
1
This OPC compatible command denotes
completion of the error coefficients transfer to
the instrument.
ial kit
her-
orrected
)ata
INPUCALK[D]
3 D Input a cal kit.
INPUDATA[D]
3 D Inputs error-corrected data.
‘ormatted
INPUPCRM[D]
3 D Inputs formatted data.
)ata
earn string INPULEAS[D]
3 D Inputs the learn string. Preceded by SELL if
learn string is not current revision.
‘ower meter INPUPMCAL<I> 3
al.
Inputs power meter cal array. Values should be
entered as 100 times the power meter reading
in dB.
bw Data
INPURAWlID]
3 D Inputs raw data.
INPURAWZ[D] 3 D
INPURAW3[D] 3 D
INPURAW4[D] 3 D
HP-IB Programrm
‘ng and Command Reference Guide
l-93